DSL
Installation - Macintosh
Thank you
for choosing STI. This guide will help you install
the DSL router and make sure your computer is properly
configured. The DSL router has been pre-configured
and is ready for you to use. Before you begin, turn
off the computer. If you requested an Ethernet card
from us, install it before continuing. See the Quick
Installation Guide that came with the Ethernet/PCI
Card.
Step
1: Connect phone cord, power supply, and Ethernet
cable (all of these are in your kit).
A. Plug one end of the phone cord directly into a
phone jack, and the other end into the "DSL"
port on the DSL router.
B. Plug one end of the Ethernet cable into your Ethernet
card (at the back or side of your computer), and the
other end into one of the LAN/Ethernet ports on the
DSL router.
C. Plug the power supply into an electrical outlet
(or surge protector), and the other end into the power
port on the DSL router.
D. Install a filter on all other devices connected
to your phone line(s). DO NOT install a filter on
the line to the DSL router. Click HERE
for more information on installing your DSL filters.
Step
2: Turn on the equipment
A. Turn on the DSL router.
B. Wait 60 seconds or until the DSL/ACT light turns
amber.
C. Turn on the computer.
Thats
it! Open your Internet browser. If you are able to
browse, the only thing left to do is to configure
your email address(es). Click Next to proceed.
If
you’re unable to browse, please visit our Troubleshooting
page.
